Cart

MacTac Iridescent Tuning Films

$67.00$1,488.00

SKU: MacTac Iridescent Tuning Films Categories:

Description

MacTac Iridescent Tuning Films

MacTac Iridescent Tuning Films
3.9 mil Polymeric Vehicle Wrap Vinyl.
• High performance low-tack repositionable adhesive.
• Great for internal or external vehicle parts.
• For flat or slightly curved surfaces.
• 80lb polycoated liner.
• Outdoor Durability 3-4 years (1-2 horizontal).

http://www.allprint.co.uk/assets/datasheets/vinyl/tuning-films-MACtac-TF/MACtac-tuningfilm-iridescent-blue-green.pdf

PRODUCT DESCRIPTION
TuningFilm Iridescent Blue-Green and Fushia-Green are
100µm soft cast vinyl films coated with a low tack high
performance acrylic adhesive.
These products have 2 colours according to the viewing
angle: either a variation between the blue and green colour,
either a variation between fuchsia & green colour.
CONSTRUCTION
Face material :
100µm soft cast vinyl, glossy, cadmium-free.
Adhesive :
Repositionable black solvent based acrylic adhesive.
Liner :
Highly stable 130 gsm white PE coated paper.
TYPICAL USES
TuningFilm Iridescent Blue-Green and Fuchsia-Green are
designed for vehicle striping and/or full car wrapping.
DURABILITY
Vertical exposure: 3-4 years in zone 1 (North & central
Europe)
Horizontal exposure : reduced by 40%
These use-life estimates are based upon accelerated ageing
studies and outdoor exposure, under conditions
experienced in vertical exposure and in West Europe.
Note : Exposure to severe temperatures and ultraviolet
light, as well as conditions in Southern European
countries, and also in tropical, sub-tropical or desert
regions, will cause a more rapid deterioration. This
also applies to polluted areas, high altitude,
horizontal and south-facing exposure.
SHELF LIFE
2 years when stored at 15 to 25°C and ± 50 % relative
humidity.
PHYSICAL PROPERTIES (Typical values)
Thickness (mm) (Film + adhesive) ISO 543
0.135
Face Material Data, 23°C DIN 53455-5
Tensile strength : > 25 N/15mm
Elongation at break : > 150 %

Adhesive Data, 23°C FTM 1
Peel adhesion 180° on stainless steel (N/25mm)
– 20 min. residence: 14
– 24 hour residence: 18
– 1 week residence: 23
Dimensional stability FTM 14
Shrinkage (48 hours at 70°C) : < 0.2 %
(25 cm x 25 cm, sample mounted on aluminium).
Temperature ranges :
Application : +15°C to + 40°C
End-use : – 40°C to + 90°C
Flammability ISO 3795
Sample mounted on aluminium : self-extinguishing.
Solvent and chemical resistance
Resistant to most oils and grease, fuel, aliphatic solvents,
weak acids, salts and alkalis.
PROCESSING
Clean and degrease the substrate
All surfaces to which the material will be applied must be
thoroughly cleaned from dust, grease or any
contamination. Use soapy water to remove the dust and
degrease the car surface with isopropylic alcohol.
Application
on flat or slightly curved surfaces
Apply directly on the car by the dry application
method.
on convex areas
Heat the film with a heat gun before stretching it over
the convex area.
on corrugated or concave areas
If the film is stretched into a too deep corrugation it
may pop-out after a few weeks. It is, therefore,
recommended to cut the film and to apply it in the
corrugation without tension.
Removability
Once heated, TuningFilm Iridescent Blue-Green and
Fuchsia-Green can be removed with small adhesive residue
on the car body.
Important remarks
The compatibility of paints and lacquers should be tested
by the end-user, prior to use

IMPORTANT NOTICE

All MACtac products are subject to careful quality control throughout the manufacturing process and are
warranted to be of merchantable quality and free from manufacturing defects.
Published information concerning MACtac products is based upon research which the Company believes to be
reliable although such information does not constitute a warranty.
Because of the variety of uses of MACtac products and the continuing development of new applications, the
purchaser should carefully consider the suitability and performance of the product for each intended use, and
the purchaser shall assume all risks regarding such use. The seller shall not be liable for damages in excess of
the purchase price of the product nor for incidental or consequential damages.
All specifications are subject to change without prior notice.

 

Additional information

Size

, ,

Brands

Product Type

Thickness

Color

, ,

Reviews

There are no reviews yet.

Be the first to review “MacTac Iridescent Tuning Films”

BCI Offers SAME DAY FREE SHIPPING On All Regular Sized Items From all Distribution LocationsDistribution Locations