Orafol ORAJET 3551 RA

Description

Orafol ORAJET 3551 RA

Orafol ORAJET 3551 RA
2.75 Mil High Performance Calendered PVC Gloss White Inkjet Vinyl.
• 7 year outdoor durability.
• Grey, opaque, repositionable, solvent-based, permanent adhesive with air-egress; clean removability for up to 4 years.
• 90lb PE-coated silicone paper liner.
• Great for vehicle and fleet wraps with simple to moderate curves.
• ORACAL suggests laminating with Oraguard 290, 290F, 293.
• Print compatibility: Solvent, Eco-Solvent, UV, Latex.

http://www.folii-adezive.ro/documente/produse/3551RA.pdf

Description
Polymeric PVC film, white in gloss and matt
Release paper
PE-coated silicone paper, 165 g/m², 180 µm
Adhesive
Solvent polyacrylate, repositionable, permanent adhesive, grey
Area of use
For long-term advertisements with highest degree of brilliancy and durability in outdoor applications, e.g. vehicle
lettering. The “Rapid Air” technology enables easy and quick bubblefree application, especially of large-sized graphics
or decals. Entrapped air can be easily removed simply by rubbing out under the film. Suitable for even or slightly
curved surfaces.
Thickness* 70 micron
Dimensional stability adhered to steel, no shrinkage in cross direction, in length 0.2 mm
max.
Temperature resistance*** adhered to aluminium, -50°C to +90°C (short-term, max. 24h, at
+100°C), no variation
Seawater resistance adhered to aluminium, after 100h/23°C no variation
Resistance to solvents and chemicals at room temperature, 72h after adhesion to aluminium, short-term
resistant to most oils and greases, fuels, aliphatic solvents, weak
acids, salts and alkalis
Adhesive power*
(FINAT TM 1, after 24h, stainless steel)
18 N/25 mm
Tensile strength (DIN EN ISO 527)
along min. 19 MPa
across min. 19 MPa
Elongation at break (DIN EN ISO 527)
along min. 130%
across min. 150%
Shelf life** 2 years
Minimum application temperature > +8°C
Service life
under vertical outdoor exposure (normal climate of Central Europe)
Not printed: 7 years
Attention:
After printing the ink must be thoroughly dry in order to avoid any affect on the later combination with the laminate.
Surfaces to which the material will be applied must be thoroughly cleaned from dust, grease or any contamination
which could affect the adhesion of the material. Freshly lacquered or painted surfaces should be allowed to dry for at
least three weeks and to completely cure respectively. The compatibility of selected lacquers and paints should be
tested by the user, prior to application of the material. ORAJET Rapid Air media are not suitable for wet application.
Furthermore the application information published by ORAFOL is to be considered. The batch traceability according
to ISO 9001 is possible on the basis of the roll number.
Technical data
(FINAT TM 14)
(DIN 50021)
* average
(without protective paper and adhesive)
** in original packaging, at 20°C and 50% relative humidity
Printing method
Inkjet printing with solvent based inks, UV- or Latex inks
Technical Data Sheet
Certificates
Class DIN 4102-B1: Only flame resistant on steel surface (indoor application, also printed)

The statements in this information sheet are based upon our knowledge and practical experience. This data is intended only as a source of
information and is given without guarantee and does not constitute a warranty. Due to the wide variety of possible uses and applications customers
should independently determine the suitability of this material for their specific purpose, prior to use.