Description
Action Tac Application Fluid
Action Tac®
Action Tac, the ready-to-use vinyl application fluid for applying pressure sensitive vinyl and decals to most surfaces.
Less Aggressive Than Other Fluids
Will Not Attack Transfer Tape and Cause Separation
One Product for All Grades Of Vinyl
A Great Prep and Cleaning Agent – One Product Does the Whole Job
Less Clean-Up Residue
Excellent Pricing
Smells Good, No Harmful Odors
Works Great!
Transport Information
Not regulated
1 quart – 4lbs (1.83 kg)
1 case (12 qts) – 25 lbs (11.34 kg)
1 gallon – 9 lbs (4.08 kg)
1 case (4 gls) – 35 lbs (15.88 kg)
Shipping Weight
Box size
9×4.5×4.5
13.875×10.675×9.5
12x13x12
12.5×12.5×12.5
Marabu Action Tac Application Fluid
Action Tac® FAQ’s
Can I use Action Tac, Splash and Window Juice on acrylic based adhesives?
Yes, on all types of adhesives. Our products are not aggressive.
Why switch to Action Tac?
Those of you who have used other ready-to-use vinyl application fluids will find that Action Tac will work on a broader array of substrates. It is less aggressive than other fluids. Our philosophy is to design a few products that can do many jobs.
Is Action Tac just a diluted Splash?
No, Action Tac and Splash have different formulations. Splash will give to give you a faster tack than Action Tac.
Why do you manufacture three products for vinyl application?
Our original formula is Splash– a great product, on the market for over 13 years.
Action Tac® Application Techniques
Ideal temperature for applying vinyl is above 40 degrees Fahrenheit.
1) Clean surface with Action Tac.
2) Place lettering (copy) on surface.
Assume that every surface is dirty and that it should be cleaned thoroughly before any transfer is made.
3) Remove backing then spray surface with Action Tac.
4) Lay and copy wet surface and squeegee down.
Action Tac is an excellent cleaner and prep agent.
5) After 1 minute (approx.) saturate tape, squeegee once more.
6) Carefully remove transfer tape, pull down at 45 degrees.
A clean surface will usually result in a good transfer.
7) Complete transfer by wiping area dry.
Further Directions:
Shake well before use.
As with all coating applications, success relies on thorough surface preparation. All surfaces must be clean prior to application of vinyl graphics. Action Tac is an excellent cleaning solution. All surfaces should be “squeaky” clean before proceeding with transfer.
Spray cleaned area with Action Tac. Larger graphics require more flooding.
Remove backing paper from pressure sensitive graphics. Lay copy on wet surface and position into place. Squeegee down to remove air bubbles and excess transfer solution. Always squeegee from center to edges.
Depending on the substrate, wait up to two minutes. Spray and flood transfer tape with Action Tac. Squeegee again if desired.
Carefully remove transfer tape by pulling tape from one corner at a 45 degree angle to the copy.
Complete transfer by wiping area dry.
Use with adequate ventilation. Wear protective gloves.
360464000
360459000