Description
Orafol ORAGUARD 240HG
Orafol ORAGUARD 240HG
1 Mil Clear High Gloss Polyvinyl Fluoride Anti-Graffiti Cold Overlaminate.
• UV protection of 5 years.
• Can be restored to like new condition for up to 7 years using naphtha (lighter fluid).
• Clear, solvent-based adhesive.
• 55lb silicone-coated paper liner.
• Designed especially for high quality long-term indoor or outdoor protection.
• Protects digital prints against vandalism such as markers and spray paint.
ORAFOL Europe GmbH – Orafolstraße 2 – D 16515 Oranienburg
Telefon: +49(0)3301/8640 – Telefax: +49(0)3301/864100
Email: [email protected] – Internet: http://www.orafol.com
Technical data sheet
2013/28
Page 1 of 1
Description
Transparent ethylene tetrafluorethylene film (ETFE), glossy, with an excellent anti graffiti effect.
Release material
Silicone coated paper, 90 g/m²
Adhesive
Solvent polyacrylate, permanent
Area of use
Excellent protection especially against graffiti and environmental influences in indoor and outdoor
application (Anti Graffiti Film) on even surfaces. If several film sheets are applied, these should not be applied with
an overlap.
Technical data
Thickness* (without paper and adhesive) 25 micron
Temperature resistance*** adhered to aluminium, -50°C to +120°C, no variation
Resistance to solvents and chemicals at room temperature, 72h after adhesion to aluminium,
resistant to water, cleaning agents, alcohol and aliphatic
solvents; no variation with short-term exposure to
ketones and esters
Adhesive power*
(FINAT TM 1, after 24 hours, stainless steel)
12 N/25 mm
Tensile strength (DIN EN ISO 527) along: min. 40 MPa
across: min. 40 MPa
Elongation at break (DIN EN ISO 527) along: min. 150%
across: min. 150%
Shelf life** 2 years
Application temperature > +8°C
Service life by specialist application
under vertical outdoor exposure (normal climate of
Central Europe)
10 years
* average ** in original packaging, at 20°C and 50% relative humidity ***normal climate of Central Europe
Note
Due to the diversity of prints and printing techniques that need to be protected and the different production methods, the user
should test the suitability of the ORAGUARD laminating film for the specific print, prior to use. Furthermore the application
information published by ORAFOL is to be considered. For the cleaning of graffiti in many cases a dry cloth or a cloth moistened
with water or isopropanol is sufficient. The batch traceability according to ISO 9001 is possible on the basis of the roll number.