ORAFOL ORAJET 3930 Photoluminescent GLOW-IN-THE-DARK Vinyl

Description

ORAFOL ORAJET 3930 Photoluminescent GLOW-IN-THE-DARK Vinyl
Description
Three-layered, light yellow, cadmium-free, high performance PVC film with a gloss surface. Once the active light source is
turned off, the film has a very strong and long lasting afterglow. Phosphorescent properties of the film will not be impaired by
repeated use. Does not contain radioactive materials.
Release Liner
89# PE-coated silicone paper
Adhesive
Clear, solvent polyacrylate, permanent
Area of Use
For indoor and outdoor marking of emergency exits and dangerous locations. For exterior use, it is recommended that the
film be combined with the laminating film ORAGUARD®
293.
Technical Data
Thickness* (without liner and adhesive) 6-mil
Luminous Density* After 10 min: 35 mcd/m2
After 60 min: 5 mcd/m2
Decay Time 750 min (0.3 mcd/m2
)
Dimensional Stability (FINAT TM-14) Adhered to steel, shrinkage 0.008” max
Temperature Resistance Adhered to aluminum, -40°F to +212°F, no variation
Adhesive Power* (FINAT TM-1, after 24 h, average) Adhered to stainless steel: 4.11 lb/in
Tensile Strength (DIN EN ISO 527) Along: Min. 12 MPa
Across: Min. 10 MPa
Elongation at Break (DIN EN ISO 527) Along: Min. 100%
Across: Min. 100%
Shelf Life** (68°F/50% relative humidity) 2 years
Minimum Life Expectancy*** (based on accepted
application procedures on vertical surfaces) 5 years (unprinted)
Minimum Application Temperature > 46°F
Available Lengths
Available Widths
10 meters, 25 meters
54”
Recommended Laminates ORAGUARD®
293
Print Compatibility Latex, Solvent, Eco-Solvent, UV Curable
For best results, utilize ORAFOL ICC profiles available at www.orafolamericas.com and allow solvent-based inks to dry for at least 24 hours
(48-72 hours preferred) at 70°F before cutting the graphic to the ink or applying a laminate.
*average ** in original packaging, at 68°F and 50% relative humidity *** standard central European climate
Note
Surfaces to which the material will be applied must be thoroughly cleaned from dust, grease or any contamination which could affect the
adhesion of the material. Freshly lacquered or painted surfaces should be completely cured. The compatibility of selected lacquers and
paints should be tested by the user, prior to application of the material. Films with structured surface are naturally more sensitive than the
unstructured. Accordingly, these films are to be treated carefully both in processing and in cleaning. Impurities affect the appearance of
structured films and require more frequent cleaning. Furthermore the application information published by ORAFOL is to be considered. The
batch traceability according to ISO 9001 is possible on the basis of the roll number.